Parallel & Series Operation
It is much lower cost and causes far fewer problems to use a single power converter correctly rated for the application rather than two or more in parallel. However, there are power converters which feature master slave parallel operation. These units are intended for modular expansion schemes and fault tolerant parallel redundant power systems.
Where power converters are overload protected by constant current limiting simple parallelling of the outputs can work to an acceptable standard. Output voltages must be set the same (as precisely as possible).
Download this whitepaper to learn more.
Read More
By submitting this form you agree to XP Power contacting you with marketing-related emails or by telephone. You may unsubscribe at any time. XP Power web sites and communications are subject to their Privacy Notice.
By requesting this resource you agree to our terms of use. All data is protected by our Privacy Notice. If you have any further questions please email dataprotection@techpublishhub.com
More resources from XP Power
MTBF: misquoted and misunderstood
Reliability is one of the most important factors that a designer needs to consider when specifying components or subsystems – particularly when t...
Parallel & Series Operation
It is much lower cost and causes far fewer problems to use a single power converter correctly rated for the application rather than two or more in ...
Peaks and Valleys
Some power supplies specify a peak load capability to support loads that are higher than the nominal continuous power for short periods. In these a...
